Info's in your email but I'll post some specs here for anyone who might run into this in the future...
-Each peg is a small cylinder with 2 gaps framed between 3 "disc" shapes. One of these gaps is beveled inside (to form the external "peg" portion) and one gap has clean right angles to the discs (the "anchor" portion that holds it in the case). It looks something like this crappy ASCII drawing below...
- Code: Select all
| |___| \__/ |
| ___ __ |
|_| |_/ \_|
-Total height (sitting on flat end) - 14/16 inch - the "outside" where you attach the strap is rounded off, otherwise it's 13.5/16"
-Total width (circumference) - 10/16 inch
-Width of non-beveled space (REALLY IMPORTANT since this is where it anchors into the case) - exactly 1/4 inch, note the flat "lip" part itself is 1/8" but this shouldn't matter too much
-The material feels like steel, but a really durable rubber or hardwood might do