Hello all, I have a Moog Source that was modified at some point to be controlled with a Lyricon Driver adding VCA and VCF control via CV signals. I just picked up a Doepfer Dark Link and am attempting to control my Moog from Logic Pro on my Mac. So far I have only tried to get the basic, stock S-Trigger and KB CV controls working.
I have been able to get the S-Trigger control working properly and am aware that the KB CV in on the Moog requires a special cable that goes from tip at the Moog to ring on the Dark Link. The problem is that except for one octave (when played from my midi controller through my computer) every key plays the same note (the last note played on the Moog's own keyboard). That particular octave isn't exactly in tune either. When I connect the cable for the KB CV to the CV1 on the Dark Link the Moog shoots up about 2 octaves when played from either my controller or the Moog itself. When I unplug the cable it goes back to the normal register. Both are supposedly working at a scale of 1V/Octave according to their manuals.
Anybody have any experience that could shed some light on this?