Spav wrote:One thing on using a composer package make sure you are using a mono channel and routing to the out correctly. I agree it would help if there was some indication that the synth is accepting input.
I think the order for receiving sysex is 95(enter) then set the midi mode to ext.
I am assuming the DK600 requires the same sysex manufacturers ID and product as the Opera 6, if you can capture a sysex dump from the DK600 and show the first few bytes F0 21 xx where xx is the product ID, if it is different for the DK 600 I will hack the sysex. I did post a link to the manual in your other thread. you must make sure that you enable write before you send the sysex to the DK600.
I will have a look at making the .mid file when I get some time. I must also get round to releasing the new firmware as this supports bulk sysex dump.
The only reaction I've gotten so far is when I've pressed 95[enter], enabled int/from and pressed record, which makes both the display and the enter button blink. If I then transmit the opera6 file using Sysex Librarian it stops blinking and reverts to 00, but it does not count upwards from there...
Users browsing this forum: No registered users and 0 guests