Sir Ruff wrote:I don't think you have a problem, you're just not eliminating the signal fully. The balance slider is the easiest way to move between VCA 1 or 2, instead of trying to turn VCA 2 "off" (which again, is not actually possible unless you prevent it's envelope from opening)
radek tymecki wrote:ok so what should i do to hear for example 100% of vcf1 and 50% of vcf2?
radek tymecki wrote:ok. but this shouldn't work like that;)
radek tymecki wrote:VCF1 and VCF2 are both placed on VCA 1 module
Users browsing this forum: No registered users and 13 guests