Quasimidi Technox

Quasimidi Technox Image

The Technox was something of a follow-up to Quasimidi's first rack-mountable synth, the "MASS" engine Quasar. The Quasar was a do-it-all multitimbral unit that was quite powerful, but had a rather lacking overall sound. The single-unit-high silver-clad Technox is a vast improvement based upon the Raven engine, though it's still a mid-90s ROMpler and so playing many sounds at the highest or lowest octaves brings out tell-tale artifacts.

But what are those sounds? Well the phrase "techno rave electronic" on the fascia would probably hint at what one would find, and indeed the presets are utterly 90's techno, rave, IDM, electronica goodness from every pore. Lots of pretty solid basses, rave leads, hooverish sounds, acid squeals, spacey pads and some great drum kits. The latter includes full sets of TR-808, 909 and 606 hits. There are 512 presets, which for a 1995 synth wasn't bad!

Whereas the Quasar excelled at providing a ton of bread-and-butter sounds, the Technox is oriented towards dance musicians. To this end, a sequencer is also included which can address up to 16 MIDI parts. Each part has its own level, pan and effects send, and much more besides. Using this and editing in general is a touch fiddly with the two knobs and four buttons, paired to a 2-line 16-character dot matrix LCD. But it isn't difficult, and while the presets tend to cover early-90s techno, a touch of editing can go a long way into many other genres. There's a lot of good stuff here for darker and ambient genres!

There's only stereo outs, but full MIDI In/Out/Thru and a foot switch jack. The Technox's greatest asset, ultimately, is its 16-part multitimbrality. Channel 10 is fixed to addressing drums, but the other 15 channels can go where you want. There are only 14 memories for these multitimbral setups, though, which is a touch limiting.

One aspect of these Quasimidi synths that throw some off is their sound creation, or rather the lack of. Similar to the Quasar, it isn't really possible to build sounds from scratch. Instead you use the preset samples and alter their settings using offset values. But where the Quasar had difficulty sounding anything more than "slightly muffled", the Technox's samples are higher quality and at least provide better starting points.

Don't expect anything close to a raw analog sound, or the sheen of a Korg workstation. While the Technox can sound a touch thin when playing single voices, a few of them mixed together can sound a lot beefier. There's a ton of good sounds in the Technox, and it is still very useable in many electronic music genres. They're not easy to find, but not all that expensive either. Not outstanding, but definitely worth a listen!

Check Quasimidi Technox Prices on eBay

The link above will take you to a search for this synth to see active listings with more images, specs and information. If you don't find it there, try looking in our forum marketplace. Our marketplace gets thousands of visits every week so make sure to check back often if you want to buy or sell a synth.

Related forum topics

Comments

Are you looking to buy or sell a Quasimidi Technox? Post an ad in Gear For Sale or a request in Gear Wanted. For spare parts and repair services check out Gear Services & Other Goods. Our forums also has a Buyer’s Guide section where you can ask for advice on buying synthesizers.

13 Visitor comments
lightman
March 13, 2012 @ 3:47 am
The downsides: The Technox is a pure ROMpler, you can only adjust a few parameters of each sound in multi or performance mode, there's no way to create a new sound from except for combining existing patches (performance mode layers). Fully closing the filter leads to a strange plucking sound, increasing resonance lets the sound almost vanish - the Filter definitely is the weakest part. ARP is okay (up, down, up-down, random), sometimes it drifts out of sync in ext. MIDI mode when the Technox is near its voice limit. The drumkits are nice but have strange panning presets (cont'd ->)
lightman
March 12, 2012 @ 3:20 pm
The Technox has no sequencer but an arpeggiator. I'm a day-one Technox user, bought it a week after it became available over here in Germany and know the thing like the back of my hand. It has a thin-ish but useable sound, FX section is good (nice reverbs and great flanger+phaser). The patch selection is okay to good, depending on the sound group. Basses could be better, pads are excellent, drums are good as well. The samples have been thinned to fit them into the Technox' memory, that's why the machine lacks that certain oomph... ...but I still use it, guess that's sayin' something.
KitKat
March 4, 2012 @ 2:02 am
It's unfortunate that the FM sounds on this aren't as editable, but you can get FM sounds from other even less expensive units anyway.

Overall good and fair write up.
 
Post Comment!
VSE Rating

It’s Good

User Rating

Rated 3.38 (124 Votes)

  • Check Prices on eBay
  • The link above will take you to a search for this synth to see active listings. If you don't find it there, try looking in our forum marketplace or post a wanted classified.
  • Specifications
  • Polyphony - 21 voices
  • Multitimbral - 16 parts
  • Oscillators - ROM sample playback. 3 samples per performance.
  • Waveforms - Various ROM samples. 64MB ROM sample bank.
  • LFO - Yes
  • Filter - Single low-pass filter per performance.
  • Envelope - ADSR envelope.
  • Effects - 18 effects across 2 effects units, FX1 for delay & reverb, FX2 for modulation (chorus, delay, flanging etc).
  • Sequencer - 16-track sequencer.
  • Arpeggiator - 1 arpeggiator.
  • Keyboard - None
  • Memory - 512 sounds, 100 performance slots, 14 multitimbral setups.
  • Control - MIDI In/Out/Thru, foot switch controller
  • Date Produced - 1995

Errors or Corrections? Send them here.